Learn Cause of Noise in the Rubber Extruder

Comments · 65 Views

The causes of abnormal noise during the work of the rubber extruder are as follows:

What happens in the reducer may be caused by bearing damage or poor lubrication, or it may be caused by gear wear, improper installation and adjustment or poor meshing, which can be achieved by rep

The causes of abnormal noise during the work of the rubber extruder are as follows:

  1. What happens in the reducer may be caused by bearing damage or poor lubrication, or it may be caused by gear wear, improper installation and adjustment or poor meshing, which can be achieved by replacing bearings, lubricating, changing gears or adjusting gear meshing conditions To solve.
  2. If the noise is a sharp scraping sound, we should consider the position deviation of the cylinder, so that it is possible to scrape off the shaft head and the transmission sleeve. This problem can be solved by adjusting the cylinder.
  3. If the cylinder makes noise, it may be that the screw bends and sweeps the cavity, or the temperature is set too low, so that the friction of the solid particles is too large. It can be processed by straightening the screw or increasing the set temperature.

If you are interested in microwave curing oven, welcome to contact us.